|

Investigating the effect of structural parameters of a track-laying vehicle suspension on its elastic response

Authors: Kuzmin A.A., Osipov A.Yu.
Published in issue: #9(14)/2017
DOI: 10.18698/2541-8009-2017-9-166


Category: Mechanical Engineering and Machine Science | Chapter: Machines, Units and Processes

Keywords: track-laying vehicle, torsion bar suspension, rocker arm length, elastic response, specific potential energy of the suspension, torsion bar diameter, suspension rigidity, admissible shear stresses
Published: 14.09.2017

The article deals with a question relevant to designing a torsion bar suspension for a high-speed track-laying vehicle, that is, selecting the optimum ratio of rocker arm length to the road wheel radius. We show that when the rocker arm length changes, the following parameters of the torsion bar suspension change as well: torsion bar diameter, suspension rigidity, specific potential energy of the suspension, period of longitudinal and angular vibrations, and admissible shear stresses. We studied a track-laying vehicle with a fully loaded mass of 12 tons, featuring 12 road wheels each 0.335 m in radius. Rocker arm length varied from 0.24 to 0.4 m. We determined the torsion bar diameter employing the maximum dynamic travel criterion and selected maximum admissible shear stresses in the torsion bar so as to enable the full suspension travel to equal the machine’s road clearance. We discovered that the only disadvantage of using short rocker arms is that admissible shear stresses must be high in that case. Consequently, when designing a torsion bar suspension and specifying admissible shear stresses, one should select the shortest rocker arms that the design allows for. Admissible shear stresses will depend on the technology of torsion bar manufacturing. Simultaneously it is necessary to verify that the period of longitudinal and angular vibrations in the machine body remains within normal range.


References

[1] Dyadchenko M.G., Kotiev G.O., Sarach E.B. Konstruktsiya i raschet podvesok bystrokhodnykh gusenichnykh mashin [Construction and calculation of fast track vehicle suspension]. Moscow, Bauman Press, 2007, 40 p.

[2] Nosov N.A., ed. Raschet i konstruirovanie gusenichnykh mashin [Calculation and designing of track vehicle]. Leningrad, Mashinostroenie publ., 1972, 559 p.

[3] Isakov P.P., ed. Teoriya i konstruktsiya tanka. T. 6. Voprosy proektirovaniya khodovoy chasti voennykh gusenichnykh mashin [Tank theory and construction. Vol. 6. Problems of traction elements designing for tracked military vehicle]. Moscow, Mashinostroenie publ., 1985, 244 p.

[4] Dmitriev A.A., Chobitok V.A., Tel’minov A.V. Teoriya i raschet nelineynykh sistem podressorivaniya gusenichnykh mashin [Theory and calculation of track unit nonlinear cushion system]. Moscow, Mashinostroenie publ., 1976, 207 p.

[5] Dyadchenko M.G., Kotiev G.O., Naumov V.N. Osnovy rascheta sistem podressorivaniya gusenichnykh mashin na EVM [Computer calculation fundamentals of track vehicle cushion system]. Moscow, Bauman Press, 2002, 52 p.

[6] Kotiev G.O., Sarach E.B. Kompleksnoe podressorivanie vysokopodvizhnykh dvukhzvennykh gusenichnykh mashin [Complex cushioning of highly-mobile two-section track vehicle]. Moscow, Bauman Press, 2010, 184 p.